OVERVIEW - HEADLAMP HOUSING MOUNT, Through MY 2012

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Headlamp Housing Bracket And Mount - Vehicles Through MY 2011

Courtesy of AUDI OF AMERICA, LLC

Headlamp Washer System Spray Nozzle
Mount
- For Headlamp Washer System Washer Fluid Line
Screw
- 8 Nm
Bracket
- For the headlamp housing mount
- Removing and installing. Refer to HEADLAMP HOUSING MOUNT BRACKET, REMOVING AND INSTALLING .
Screw
- 8 Nm
Ventilation
- For the headlamp housing
Breather Hose
- For the headlamp housing
Screw
- 4.5 Nm
Spring Nut
Mount
- For the headlamp housing
- Removing and installing. Refer to HEADLAMP HOUSING MOUNT, REMOVING AND INSTALLING .
Screw
- 4.5 Nm
Screw
- Tightening Specification. Refer to COMPONENT LOCATION OVERVIEW - AIRBAG CRASH SENSORS .
Front Airbag Crash Sensor
- Removing And Installing. Refer To DRIVER SIDE AIRBAG CRASH SENSOR -G179- / FRONT PASSENGER SIDE AIRBAG CRASH SENSOR -G180-, REMOVING AND INSTALLING / DRIVER FRONT AIRBAG CRASH SENSOR -G283-, REMOVING AND INSTALLING .