Remove Mounting Grommets -2- From The Body Opening And Throw Away.

WARNING: This page is about a different variant/trim than selected.

-- Remove Mounting Grommets -2- From The Body Opening And Throw Away.

Fig 1: Check Floor Panel For Deformation And Adjust If Necessary

Courtesy of AUDI OF AMERICA, LLC

-- Check the floor panel for deformation and adjust if necessary. Refer To FLOOR PANEL FOR BENCH SEAT MOUNTING GROMMETS AND WIRE FRAME, CHECKING AND ALIGNING .

-- Check the wire frame for deformation and adjust if necessary. Refer To FLOOR PANEL FOR BENCH SEAT MOUNTING GROMMETS AND WIRE FRAME, CHECKING AND ALIGNING .

-- Lift floor covering -3- and press in new mounting grommets -2- until they engage audibly in body opening -1-.

-- Place floor covering -3- around grommet -2- as shown.

NOTE:

Floor Covering -3- May Not Be On Grommet -2-.

Make sure the seat heating electrical collections slide on and engage audibly.

-- Insert Bench Seat -1- And Press Wire Frame -2- "Firmly" Into Grommets -3-.

Fig 2: Insert Bench Seat And Press Wire Frame "Firmly" Into Grommets

Courtesy of AUDI OF AMERICA, LLC

-- Ensure That Wire Frames -2- Are Engaged Correctly In Grommets -3-.

NOTE:

The Bench Seat Must Finally Be Checked For Secure Fit.

-- For this purpose, grab with both hands under the seat frame on one side of the seat in direction of -A arrows- and pull evenly >>not abruptly<< upward with a force of approx. 100 to 150 N >>i.e., approx. 10 to 15 kg<<.

-- Repeat the procedure on the other side in direction of -B arrows-.

NOTE:

The Bench Seat Must NOT Disengage From The Grommets.

-- If the bench seat does disengage, the entire procedure must be repeated. Refer To SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .