Floor Panel For Bench Seat Mounting Grommets And Wire Frame, Checking And Aligning

WARNING: This page is about a different variant/trim than selected.

Check And Adjust The Floor Panel.

Fig 1: Check Floor Panel For Deformation And Adjust If Necessary

Courtesy of AUDI OF AMERICA, LLC

-- Check body openings -1- for deformations.

-- In the case of deformation, readjust the panel with a plastic hammer.

NOTE:

Remaining Minor Deformation Is Permissible.

Check And Adjust The Bench Seat Wire Frame.

Fig 2: Check And Adjust Bench Seat Wire Frame

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Illustration Of The Seat Foam Can Deviate From The Real Bench Seat. Regardless Of The Shape Of The Seat Foam, Dimension -A- Must Be Measured Between The Upper Edge Of The Seat Foam And The Upper Edge Of The Wire Frame.

-- Place The Bench Seat With The Cover On A Clean Stable Surface.

-- Check Dimension -A- On Both Sides Of The Seat Frame, From The Padding To The Upper Edge Of The Wire Frame. Dimension -A- >>Must Be 16 To 22 mm.<<

-- If Dimension -A- Does Not Meet The Specification, The Wire Frame Must Be Adjusted To Meet The Specification. For This Purpose Evenly Adjust The Wire Frame In The Area Of The -Motion Arrows-.