Starter, Removing And Installing, Vehicles With 4.2L FSI Engine: Removing

-- Remove The Engine/Transmission Assembly. Refer To TRANSMISSION - REMOVING AND INSTALLING [0B4] , TRANSMISSION, ASSEMBLY SEQUENCE [0B2 AWD] .

-- Remove The Right Catalytic Converter. Refer To CATALYTIC CONVERTER, REMOVING AND INSTALLING - [FOR ENGINE CODES : CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB] , CATALYTIC CONVERTER, REMOVING AND INSTALLING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] , EMISSIONS CONTROL [FOR ENGINE(S) CALA] , CATALYTIC CONVERTER, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA]ENGINE OIL (CHECK OIL LEVEL) .

-- Remove The Generator. Refer To GENERATOR, REMOVING AND INSTALLING, VEHICLES WITH 4.2L FSI ENGINE .

Expanding The Scissor Lift Table: 

-- Fit the Scissor Lift Table:VAS6131 A  using the Scissor Lift Table - Audi Set: VAS6131/10  as follows:

Table Coordinates	Components from Scissor Lift Table - Audi Set:VAS6131/10
G2	/10-1	/10-4	/10-5	/10-12

-- Rotate The Support Set Spindle Up Until The Mounting Pin Comes Into Contact With The Mounting Point.

-- Tighten The Mounting Element Base Plate To 20 Nm  On The Scissor Lift Table:VAS6131 A  .

-- Disconnect The Connector -2- To The Right Electrohydraulic Engine Mount Solenoid Valve -N145- And Free It Up.

-- Remove The Bolts -1 And 4- And -Arrows- For The Right Engine Mount Retaining Plate.

-- Free Up The Wiring Harness On The Retaining Plate -3- On The Right Engine Mount.

-- Lay The Engine Mount Retaining Plate Aside.

-- Remove The Bolt -arrow-.

-- Remove The Bolt -2- And Lay The Secondary Air Pipe Aside.

-- Remove The Nut -1- And Free Up The Ground Wire On The Right Engine Support.

-- Remove The Bolts -Arrows- And The Right Engine Support With The Engine Mount.

-- Remove The Electrical Wire -2- On The Starter.

-- Disconnect The Connector -3- By Sliding The Retainer Back And Pressing The Release Down.

-- Remove The Bolts -1- And -4- And Remove The Starter.