Step 4 - Final Procedures:

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Close the filler lever on the :VAS5234 .

-- Remove the filler hose from the adapter.

-- Remove the adapter from the brake fluid reservoir.

-- Check the brake fluid level and correct if necessary, while considering the brake pad wear. Refer to BRAKE FLUID LEVEL, CHECKING .

-- Install the brake fluid reservoir cap.

-- Press the clutch pedal several times.

-- Check the pedal pressure and the free play on the brake pedal. Free play: maximum ¹ /₃ of the pedal travel.

-- Before driving the vehicle for the first time: Make sure the brakes are working correctly.

-- If there is too much brake pedal free play or the brake function is faulty, check the brake system for leaks and change the brake fluid again.

NOTE:

The bleeder hose must fit tightly over the bleed screw to prevent air from getting into the brake system.

For certain tire combinations, it may be necessary to remove the wheels.

Depending on the vehicle equipment, the rear brakes or front and rear brakes may be bled without removing the tires using the :VAS6564 .

Use original Audi brake fluid.

Used brake fluid may not be used again.

Observe the disposal regulations for brake fluid.