Bumper Cover, Removing And Installing, Vehicles From My 2015: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Check all adjusting mechanisms -2- by turning the adjusting nut -1- slightly -arrows-.
-- Screw the adjusting nuts all the way downward, but do not tighten.
-- Set the bumper cover in the installation position.
-- Check the gap dimensions. Refer to BUMPER COVER GAP DIMENSION .
-- Tighten the bolts.
NOTE:
When removing the bolt, the adjusting nut on the adjusting mechanism turns by itself towards the mounting point on the bumper cover and secures it.