Fuel level sensor G , removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Observe safety precautions → Safety precautions when working on fuel supply system .

Observe rules for cleanliness → Rules for cleanliness .

Remove fuel delivery unit → Fuel delivery unit, removing and installing .

Fig 1: Identifying Fuel Level Sensor G Retaining Tabs

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release retaining tabs - arrows - with a screwdriver and pull Fuel Level Sensor G upward and out.

CAUTION: Before remove electrical connectors on Fuel Level Sensor G , first release contact retaining tabs.

Fig 2: Identifying Fuel Level Sensor G Electrical Connectors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disengage electrical connectors - 1 - and - 2 - and disconnect them.

Installing

Installation is in reverse order of removal. Note the following:

Connect electrical connections - 1 - and - 2 - and check that they are securely engaged.
Insert fuel level sensor G in guides on fuel delivery unit and push down until it engages.
Install fuel delivery unit Installing , observing notes for connecting battery →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET
.