Oil pump, lower section of oil pan, component overview: Notes

WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Oil Pump, Lower Section Of Oil Pan, Component Overview

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - 9 Nm

2 - Oil pan (lower section)

Removing and installing → Lower part of oil pan, removing and installing
With Oil Level Thermal Sensor G266
Oil Level Thermal Sensor G266 , removing and installing → Oil Level Thermal Sensor G266 , removing and installing

3 - Side panel

For baffle box

4 - 9 Nm

5 - Oil pipe

6 - Gasket

Replace

7 - O-ring

Replace

8 - 9 Nm

9 - Baffle box

10 - 9 Nm

11 - Housing

For oil check valve

12 - Gasket

Replace

13 - Oil check valve

14 - O-ring

Replace

15 - Oil pipe

16 - 9 Nm

17 - Drive shaft for coolant pump

18 - Fitting sleeves

2 pieces

19 - Oil pump

Do not disassemble
With relief valve approx. 5.5 bar
Removing and installing → Oil pump, removing and installing

20 - Drive shaft for oil pump

21 - 8 Nm plus an additional 90 ° ( ¹ /₄ turn)

Replace

22 - O-ring

Replace

23 - 9 Nm

24 - Gasket

Replace

25 - Housing for intake tube

26 - 9 Nm

27 - Oil strainer

Clean

28 - 9 Nm

29 - Intake tube

For oil pump

30 - 9 Nm

31 - Seal

Replace

32 - Oil drain plug, 25 Nm