Oil Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification, refer to OVERVIEW - OIL PAN/OIL PUMP .

Install in reverse order of removal. Note the following:

NOTE:

Replace the seal and O-ring.

-- Install oil pump onto the driveshaft and fasten.

-- Install the oil pan lower section, refer to Installing .

-- Fill the engine oil and check the oil level, refer to ENGINE OIL LEVEL, FILLING AND CHECKING .