Left Coolant Pipes, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification, refer to OVERVIEW - COOLANT PIPES .

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-ring.

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

-- Clean and smooth the O-ring sealing surface.

-- Coat the O-ring with coolant and slide it onto the coolant pipe.

-- Install the A/C compressor bracket, refer to OVERVIEW - RIBBED BELT DRIVE .

-- Install the A/C compressor, refer to A/C COMPRESSOR, REMOVING AND INSTALLING .

-- Install the After-Run Coolant Pump -V51-, refer to After-Run Coolant Pump -V51-, REMOVING AND INSTALLING .

-- Fill with coolant, refer to COOLANT, DRAINING AND FILLING .