Overview - Timing Chain Cover: Notes

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Timing Chain Cover

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Replace
- Tightening specification and sequence, refer to LOWER TIMING CHAIN COVER, TIGHTENING SPECIFICATIONS AND SEQUENCE .
Sensor Wheel
- for Engine Speed Sensor -G28-
Shaft Seal
- For the crankshaft on the transmission side
- Removing and installing, refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
Lower Timing Chain Cover
- Removing and installing, refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
Alignment Sleeve
Seal
- Replace
Bolt
- Replace
- Tightening specification and sequence, refer to Figure.
Left Timing Chain Cover
- Removing and installing, refer to TIMING CHAIN COVER, REMOVING AND INSTALLING .
Bolt
- Replace
- Tightening specification and sequence, refer to Figure.
Seal
- Replace
Bolt
- Replace
- Tightening specification and sequence, refer to Figure.
Right Timing Chain Cover
- Removing and installing, refer to TIMING CHAIN COVER, REMOVING AND INSTALLING .
Bolt
- Replace
- Tightening specification and sequence, refer to Figure.
Alignment Sleeve
Seal
- Quantity: 2
Engine Speed Sensor -G28-
- Overview, refer to OVERVIEW - GLOW PLUG SYSTEM .
Bolt
- Tightening specification: 9 Nm