Brake Caliper, Replacing, Brake 1LV And 1ZK, Sq5: Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening specifications, refer to OVERVIEW - FRONT BRAKES, 1LV AND 1ZK, SQ5 .
NOTE:
Use new bolts, allocate correct bolts.
-- Install the brake pads, refer to BRAKE PADS, REMOVING AND INSTALLING, BRAKE 1LV AND 1ZK, SQ5 .
-- Install the brake hose into the brake caliper and tighten.
WARNING:
- Brake fluid is poisonous. NEVER siphon brake fluid with your mouth!
- Wash off any brake fluid that comes into contact with the skin with a lot of water.
- If brake fluid comes in contact with the eyes, wash out the eye(s) and see a doctor.
- Refer to BRAKE FLUID GENERAL INFORMATION
-- Remove the Brake Pedal Actuator VAG1869/2.
Only bleed the brakes on the wheel which the brake caliper and the brake line was separated.
NOTE:
Only bleed the brakes on the wheel which the brake caliper and the brake line was separated. If the brake pedal still feels "soft", completely bleed the brakes, refer to HYDRAULIC SYSTEM, BLEEDING .
-- Refer to HYDRAULIC SYSTEM, BLEEDING
WARNING:
There is the risk of an accident.
- Before moving the vehicle, press the brake pedal firmly several times to seat the brake pads correctly in their operating position.
- Make sure the brakes are working correctly before driving the vehicle.