Mounting Bracket, Removing And Installing, Vehicles With Manual Transmission: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to OVERVIEW - BRAKE PEDAL .

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp switch -10- if the brake pedal is released too quickly.

Fig 1: Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

Make sure the seal on the clutch master cylinder is seated properly before inserting the mounting bracket.

-- Install the mounting bracket into the guides in the vehicle.

Guide the clutch master cylinder through the opening on the mounting bracket while slightly turning it to the right so that the cylinder mount fits through mounting bracket.

-- Install the nuts on the mounting bracket guides and secure it.

-- Install the bolts from the brake booster -1- to the mounting bracket and tighten them.

Fig 2: Brake Booster Bolts, Brake Lines & Brake Master Cylinder Bolts

Courtesy of AUDI OF AMERICA, LLC

NOTE:

First install the bolts from the brake booster to the mounting bracket and tighten them.

-- Tighten the nuts -16- on the mounting bracket guides.

Fig 3: Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

-- Install clutch master cylinder.

-- Install over-center spring.

-- Connect the connector to the accelerator pedal module.

-- Refer to BRAKE PEDAL, ATTACHING TO BRAKE BOOSTER .

-- Install steering column, refer to STEERING COLUMN, REMOVING AND INSTALLING .

-- Install cover for brake fluid reservoir.

-- Install the plenum chamber bulkhead, refer to OVERVIEW - BULKHEAD .