Overview - Brake Pedal
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Grease all bearings and contact surfaces with Polycarbamide Grease G 052 142 A2
- Mounting Bracket for Pedal Assembly
- Illustration for vehicles with automatic transmission
- Refer to MOUNTING BRACKET, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .
- Refer to BRACKET, REMOVING AND INSTALLING; VEHICLES WITH S TRONIC-/AUTOMATIC TRANSMISSION .
- Sleeve
- Brake Pedal Axle
- Mounting Pin
- Right Securing Clip (Spring Steel)
- Allocate correct components.
- Washer
- Gas Pedal Module Bolt
- Tightening specification: 8 Nm
- Accelerator Pedal Module
- Bolt
- 8 Nm
- Brake Pedal Position Sensor -G100-
Only for hybrid vehicles
- Brake Lamp Switch -F-
- Magnet Carrier
Only for hybrid vehicles
- For the brake pedal position sensor
- The centering pin -arrow- must audibly engage when installing at the brake pedal
- Pedal Support Bolt
- 20 Nm
- Mounting Pin Bolt
- 8 Nm
- The bolt holds the mounting pins in position
- Left Securing Clip (Spring Steel)
- Allocate correct components.
- Brake Pedal
- Refer to BRAKE PEDAL, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION
- Refer to BRAKE PEDAL, REMOVING AND INSTALLING; VEHICLES WITH S TRONIC/AUTOMATIC TRANSMISSION WARNING:
- The path of the brake pedal must not be shortened via extra floor mats.
- Ball Socket Formed in Mount
- For the ball head on the brake booster push rod
- Mount
- For the ball head on the brake booster push rod
- With ball stud retaining tabs
- Refer to BRAKE BOOSTER PLUNGER MOUNT, REMOVING AND INSTALLING
- Nut
- 8 Nm
- StopNOTE:
If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp switch if the brake pedal is released too quickly.
- Grommet
- Only installed on vehicles with automatic transmission