Bracket, Removing And Installing; Vehicles With S TRONIC-/Automatic Transmission: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Refer to BRAKE PEDAL, REMOVING FROM BRAKE BOOSTER .

-- Disconnect the connector from the accelerator pedal module.

Applies to hybrid vehicles

WARNING:

Follow the High Voltage System General Warnings, refer to HIGH VOLTAGE SYSTEM GENERAL WARNINGS .

-- Remove the Electric A/C Compressor High Voltage Cable -P3- from the plenum chamber bulkhead, refer to ELECTRICAL A/C COMPRESSOR HIGH VOLTAGE CABLE, REMOVING AND INSTALLING .

Continuation for all vehicles

-- Remove the plenum chamber bulkhead, refer to OVERVIEW - BULKHEAD .

-- If installed: Remove the brake fluid reservoir cover.

-- Remove the bolts mounting the brake booster -1- to the mounting bracket.

Fig 1: Brake Booster Bolts, Brake Lines & Brake Master Cylinder Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -16- on the mounting bracket guides.

Fig 2: Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

-- Turn the steering wheel with the steering wheel adjustment as far as possible to the rear, toward the driver seat.

-- Move the steering wheel into the straight-ahead position The vehicle wheels are in the straight-ahead position as well.

NOTE:

It is not necessary to remove the instrument cluster and steering in order to remove the steering column.

-- Remove the lower bolts -2- on the steering column.

Fig 3: Identifying Steering Intermediate Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Remove the lower bolts -2 through 4- for the steering column and mounting bracket.

Fig 4: Identifying Lower Steering Column Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the gap cover -2- from the upper trim -1- for the steering column switch module -arrow A-.

Fig 5: Using A Small Flat-Head Screwdriver, Carefully Unclip Gap Cover From Upper Steering Column Switch Module Trim

Courtesy of AUDI OF AMERICA, LLC

-- Remove the cable guides on the steering column.

NOTE:

the steering wheel is not shown in the illustration. It is not necessary to remove the steering wheel and instrument cluster.

-- Remove the steering column bolts -1 and 2- on the central tube while supporting the steering column from below with the hand.

Fig 6: Identifying Steering Column Bolts

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Loosen and remove the bolts -1 and 2- using a commercially available ratchet with a 3/8" drive and socket and extension.

-- Pull the steering column out of the steering shaft

-- Carefully lay down the steering column and steering wheel.

-- Remove the mounting bracket from the vehicle.