Brake Pedal, Removing From Brake Booster

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Brake Servo Release Tool T40136

Disconnecting

Fig 1: Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Brake Lamp Switch -F-.

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp switch -10- if the brake pedal is released too quickly.

-- First move the brake pedal toward the brake booster and the hold it in this position.

Fig 2: Inserting Brake Servo Release Tool T40136

Courtesy of AUDI OF AMERICA, LLC

1 - Brake Pedal

2 - Pressure rod

3 - Retaining tabs

-- Insert the Brake Servo Release Tool T40136 and pull in the direction of the driver seat as illustrated. When doing this, counter-hold at the brake pedal (the pedal must not be allowed to move backward at this time). The mounting retaining lugs -3- will thereby be pressed off the ball head of the push rod -2-.

For ease of illustration separating the brake pedal from the brake booster is shown with the pedal assembly removed.

-- Pull the Brake Servo Release Tool T40136 and brake pedal together toward the driver seat. (This will pull the brake pedal off the push rod ball head).