Overview - Reducing Agent Tank

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Installed Location: rear seat hole left under the underbody.

Fig 1: Overview Of Reducing Agent Tank

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Tightening specification: 4.2 Nm
Aerodynamic Trim Left Rear
- Removing and installing, refer to OVERVIEW - UNDERBODY PANELS
Heat Shield
- For Reducing Agent Tank
Reducing Agent Tank
- Removing and installing, refer to REDUCING AGENT TANK, REMOVING AND INSTALLING .
Filling Line
- Disconnect the wires for the reducing agent, refer to REDUCING AGENT DELIVERY LINE, REMOVING AND INSTALLING .
- From filler tube
  WARNING:
  Danger due to reducing agent leaking out.
  - Read safety precautions for handling reducing agent, refer to SCR SYSTEM SAFETY PRECAUTIONS .
Breather Line
- Disconnect the wires for the reducing agent, refer to REDUCING AGENT DELIVERY LINE, REMOVING AND INSTALLING .
- From filler tube
  WARNING:
  Danger due to reducing agent leaking out.
  - Read safety precautions for handling reducing agent, refer to SCR SYSTEM SAFETY PRECAUTIONS .
Sleeve
Grommet
Sleeve
Bolt
- Tightening specification: 20 Nm
Nut
- Tightening specification, refer to OVERVIEW - UNDERBODY PANELS .