Fuel Tank Pressure Sensor -G400-, REMOVING AND INSTALLING, AUDI Q5 HYBRID: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specification, refer to OVERVIEW - EVAP SYSTEM, AUDI Q5 HYBRID .

NOTE:

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

-- Install the left rear wheel housing liner, refer to WHEEL HOUSING LINER .

-- Install the left rear wheel, wheel bolt tightening specification: 140 Nm. .