Overview - EVAP System, AUDI Q5 Hybrid
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Vent Line
- Not for USA Vehicles
- Honeycomb Filter 1
- Removing and installing, refer to HONEYCOMB FILTER 1, REMOVING AND INSTALLING, AUDI Q5 HYBRID .
- Seal
- Insert into the EVAP canister
- Bolt
- 2.8 Nm
- Quantity: 2
- Evaporative Emission (EVAP) Canister
- Component location: on the underbody under the rear left floor panel
- Removing and installing, refer to EVAP CANISTER, REMOVING AND INSTALLING, AUDI Q5 HYBRID .
- Bolt
- 16 Nm
- Quantity: 3
- Rubber Grommet
- Quantity: 3
- Insert into the EVAP canister
- Bushing
- Quantity: 3
- Insert into the rubber grommet
- Bracket
- For the EVAP canister
- Vent Line
- To the left rear of Fuel Tank Pressure Sensor -G400- under the wheel housing liner
- Clipped to bracket in the wheel housing under the wheel housing liner
- Fuel Tank Leak Detection Control Module -J909-
- Installed location: on the right front of the fuel tank
- Removing and installing, refer to FUEL TANK LEAK DETECTION CONTROL MODULE, REMOVING AND INSTALLING .
- Nut
- 1.6 Nm
- Quantity: 2
- Hose
- To air filter
- Hose Clamps
- Must be appropriate for the model type .
- Fuel Tank Pressure Sensor -G400-
- Installed location: under the wheel housing liner in left rear wheel housing
- Removing and installing, refer to FUEL TANK PRESSURE SENSOR, REMOVING AND INSTALLING .
- Bracket
- For Fuel Tank Pressure Sensor - G400- and air filter
- Removing and installing, refer to FUEL TANK PRESSURE SENSOR, REMOVING AND INSTALLING .
- Air Filter
- For the leak detection system
- Installed location: under the wheel housing liner in left rear wheel housing
- Removing and installing, refer to LEAK DETECTION SYSTEM AIR FILTER, REMOVING AND INSTALLING .
- Bolt
- 5 Nm
- Bolt
- 1.5 Nm
- Quantity: 3
- Nut
- 5 Nm
- Quantity: 3
- Breather Line
- From the fuel tank
- To disconnect, press release button on the connection piece.
- Breather Line
- To EVAP Canister Purge Regulator Valve 1 -N80-
- To disconnect, press release button on the connection piece.
- Clipped to the bracket
- Bolt
- 1.5 Nm
- Quantity: 4
- Bracket
- For the honeycomb filter
- Removing and installing, refer to HONEYCOMB FILTER BRACKET, REMOVING AND INSTALLING, AUDI Q5 HYBRID .
- Hose
- Honeycomb Filter 2
- Removing and installing, refer to HONEYCOMB FILTER 2, REMOVING AND INSTALLING, AUDI Q5 HYBRID .
- Hose clamps
- Must be appropriate for the model type .