Coolant Pump, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and the O-rings.

-- Coat the O-rings -4- with coolant. For the correct coolant, refer to Parts .

Fig 1: Accessory Assembly Bracket, Coolant Pump Housing, Connection And O-Rings

Courtesy of AUDI OF AMERICA, LLC

-- Make sure both centering pins are installed in the cylinder block.

-- Install the connection piece -2- into the engine oil cooler -1-.

-- Push the coolant pump -3- onto the connection piece and onto the centering pins in the cylinder block.

-- Tighten the coolant pump bolts, refer to Figure.

Fig 2: Coolant Pump Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If a new coolant pump was installed, then the protective cap -arrow- must be removed.

-- Install the toothed belt on the coolant pump, refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- Install the Throttle Valve Control Module -J338-, refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .

-- Install the small coolant pipe, refer to SMALL COOLANT PIPE, REMOVING AND INSTALLING .

-- Connect the coolant hose to the coupling, refer to Figure.

NOTE:

Do not reuse used coolant.

Filling for Non-Hybrid Vehicles, or Filling for Hybrid Vehicles.

Tightening specifications

Refer to OVERVIEW - COOLANT PUMP/THERMOSTAT