Overview - Coolant Pump/Thermostat
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening sequence, refer to Fig 2
- O-Rings
- Replacing
- Connection
- Clip
- Only with the inserted version
- Make sure it is secure
- Bolt
- 4 Nm
- Only with the threaded version
- Retaining Plate
- Only with the threaded version
- Engine Coolant Temperature Sensor -G62-
- Removing and installing, refer to Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING .
- O-Ring
- Replacing
- Coolant Pump
- Removing and installing, refer to COOLANT PUMP, REMOVING AND INSTALLING .
- With a new coolant pump, remove the protective cap
- Seal
- Replacing
- Centering Pin
- Quantity: 2
- Toothed Belt
- For the coolant pump
- Removing and installing, refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .
- Toothed Belt Cover
- Bolt
- 9 Nm
- Bolt
- 10 Nm + 90° turn
- Replacing
- Left thread
- Drive Gear for Toothed Belt
- Pay attention to the installed position.
- Balance Shaft Seal, Exhaust Side,
- Replacing, refer to BALANCE SHAFT SEALING RING, REPLACING, INTAKE SIDE .
- Balance Shaft
- Coolant Thermostat
- Removing and installing, refer to COOLANT THERMOSTAT, REMOVING AND INSTALLING .
- Centering Pin
- O-Ring
- Replacing
- Connection
- Bolt
- 9 Nm
-- Tighten the coolant pump bolts to 9 Nm in the order -1 to 5-.