LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 653 (2.0L - Engine Cooling System - Engine Code(S): CAEB, CHJA, CPMA & CPMB) >> 19 Cooling System >> Coolant Pipe >> Coolant Pipes, Removing And Installing >> Small Coolant Pipe, Removing And Installing >> Installing

Small Coolant Pipe, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-rings.

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

In order to be able to securely mount the air guide hoses on their connectors, spray the screws on the previously used clamps with a rust remover.

-- Connect the coolant hose to the coupling, refer to Figure.

-- Install the air guide hose, refer to OVERVIEW - CHARGE AIR SYSTEM .

-- Install the electric wires, refer to appropriate SYSTEM WIRING DIAGRAM.

NOTE:

Do not reuse used coolant.

Filling  for Non-Hybrid Vehicles, or Filling  for Hybrid Vehicles.

Tightening specifications 

scientia non olet · About LEMON Manuals