LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 640 (2.0L - Crankshaft & Cylinder Block - Engine Code(S): CAEB, CHJA, CPMA & CPMB) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Drive Plate, Removing And Installing >> Installing

Drive Plate, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the drive plate bolts.

Manual transmission vehicles have a needle bearing inside the drive plate. Check if the needle bearing is inserted before installing. Remove needle bearing from drive plate and install, refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .

-- Be careful of the alignment bushings during installation.

-- Reposition the Counterhold - Flywheel 10-201 to tighten the bolts.

scientia non olet · About LEMON Manuals