Needle Bearing In Drive Plate, Replacing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Only vehicles with manual transmission have a Needle Bearing in Drive Plate.
Special tools and workshop equipment required
- Press Piece - 31.5 mm VW418A
- Press Piece - 28x100mm VW421
- Bearing Installer - Multiple Use 40-103
Procedure
- The transmission is removed.
-- Remove the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- To remove and install, place the Bearing Installer - Multiple Use 40-103 under the drive plate.
-- Press out the needle bearing using the Press Piece - 28x100mm VW421 and workshop press.
- The smaller diameter of the Press Piece - 28x100mm VW421 faces the drive plate.
-- Carefully press the needle bearing in as far as the stop using the Press Piece - 31.5mm VW418A and shop press.
- Installed position: the closed side of the needle bearing faces the engine.
-- Install the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .