Rear Axle Toe, Adjusting
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Track Rod Tool Insert T40183
- Commercially Available Pawl with Fine Gear
-- Remove the nut -A- of threaded connection tie rod/subframe, and screw on new nut until stop.
-- Adjust toe by turning eccentric screw -B-.
Axle alignment specified values, refer to WHEEL ALIGNMENT SPECIFIED VALUES .
-- Tighten the nut -A- using the Track Rod Tool Insert T40183, refer to OVERVIEW - UPPER TRANSVERSE LINK, TIE ROD, COIL SPRING, LOWER TRANSVERSE LINK AND LEVEL CONTROL SYSTEM SENSOR -item 25-, Nut.
-- After tightening nut -A-, check toe value once more, refer to WHEEL ALIGNMENT SPECIFIED VALUES .
NOTE:
The maximum adjustment range is 90° to left or right of center position.
The geometric drive axle is automatically changed when individual toe settings are changed.