Rear Axle Camber, Adjusting

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the nut -A- of threaded connection of wheel bearing housing/control arm, and screw on new nut until stop.

Fig 1: Identifying Nut On Threaded Connection Wheel Bearing Housing/Control Arm And Bolt On New Nut Until Stop

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the camber by rotating the adjusting bolt -B-. To turn the adjusting screw -B-, turn the hex head at the >>top of the screw<<.

Axle alignment specified values, refer to WHEEL ALIGNMENT SPECIFIED VALUES .

NOTE:

The maximum adjustment range is 135° to left or right of center position.

Do not rotate the adjusting bolt -B- further once the end position has been reached or the components will be damaged.

For a better illustration, camber adjustment is shown with wheel removed.

-- Tighten nut -A-, refer to OVERVIEW - UPPER TRANSVERSE LINK, TIE ROD, COIL SPRING, LOWER TRANSVERSE LINK AND LEVEL CONTROL SYSTEM SENSOR -item 9-, Nut -A-.

-- After tightening nut -A-, check camber value once more, refer to WHEEL ALIGNMENT SPECIFIED VALUES .