POWER STEERING PUMP, REMOVING AND INSTALLING, VEHICLES WITH DYNAMIC STEERING, Vehicles with 6-Cylinder FSI Engine: Notes

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Hose Clamps - Up To 25 mm 3094
Wrench - Pin Type 3212
Hose Clip Pliers VAG1275A
Torque Wrench 1331 5-50Nm VAG1331
Torque Wrench 1331 Insert - Reversible Ratchet VAG1331/1
Torque Wrench 1331 Insert - Flared Ring Wrench - 17mm VAG1331/10
Used Oil Collection and Extraction Unit SMN372500
Shop Crane - Drip Tray VAS6208
Torque Wrench 1410 VAG1410
Torque Wrench 1410 Insert - Ratchet VAG1410/3
Engine Bung Set VAS6122

Power Steering Pump, Removing and Installing, 6-Cylinder FSI Engine, Vehicles with Dynamic Steering, refer to REMOVING

Overview - Power Steering Pump

NOTE:

Replace seals.

Do not reuse fluid you have drained.

Only use Hydraulic Fluid.

Fig 1: Identifying Power Steering Pump, Vehicles With Dynamic Steering (6-Cylinder FSI)

Courtesy of AUDI OF AMERICA, LLC

Bracket
Sleeve
- Drive the sleeve back slightly to install the power steering pump.
Bolt
- 20 Nm
Clamp
- Tension using Hose Clip Pliers VAG1275A, refer to Figure
- Always replace if removed
Suction Hose
- The "P" marking on the suction hose -arrow- must align with the formed seam -arrow- on the power steering pump.
Power Steering Pump Regulator Valve
- The power steering pump and the control valve are one component and can only be replaced together.
Power Steering Pump -V119-
- With power steering pump regulator valve
- The power steering pump and the control valve are one component and can only be replaced together. Refer to -item 6- "Power Steering Pump Regulator Valve"
- Allocation, refer to parts.
- Fill with Hydraulic Fluid before installing
- Delivery pressure, checking, refer to POWER STEERING PUMP, CHECKING DELIVERY PRESSURE .
- Removing and installing, refer to REMOVING .
- Bleed the steering, refer to STEERING, BLEEDING AFTER REPLACING .
- Check hydraulic fluid level, refer to POWER STEERING FLUID LEVEL, CHECKING .
- Steering System, checking for leaks, refer to STEERING, CHECKING FOR LEAKS .
Seal
- Always replace if removed
Union Nut
- 38 Nm
- 36 Nm, this tightening specification applies only with the Torque Wrench 1331 Insert - Flared Ring Wrench - 17mm VAG1331/10
Pressure Line
CAUTION:
- Insert the pressure line completely when installing.
- Note the installation position: the angle between the line connection and the power steering pump axle must be approximately 59°.
- depending on the version, also mounted to the A/C compressor
Bolt
- 22 Nm
Belt pulley
Bolt
- 20 Nm
Bolt
- 20 Nm
Bolt
- 20 Nm
- For securing the power steering pump to the bracket.
Bolt
- 20 Nm