Power Steering Fluid Level, Checking

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Do not run engine and turn front wheels to straight ahead position.

Fluid cold (approximately 20 °C (68 °F)):

-- Remove the cap.

-- Wipe dipstick off with a clean cloth.

-- Screw cap on hand-tight and unscrew again.

NOTE:

The cap must be fully screwed in order to obtain an accurate fluid level reading.

-- Check the oil level: the oil level must be in the -A- range.

Fig 1: Identifying Fluid Level Range

Courtesy of AUDI OF AMERICA, LLC

Fluid at operating state temperature (approximately 80 °C (176 °F)):

-- Remove the cap.

-- Wipe dipstick off with a clean cloth.

-- Screw cap on hand-tight and unscrew again.

NOTE:

The cap must be fully screwed in order to obtain an accurate fluid level reading.

-- Check the oil level: the oil level must be in the -B- range.

Fig 2: Identifying Fluid Level Range

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Fluid must be drawn off if the level is above the specified range.

If oil level is below aforementioned area, then the hydraulic system must be checked for leaks. It is not enough to just add fluid.

Do not use drained hydraulic oil.