POWER STEERING PUMP, REMOVING AND INSTALLING, VEHICLES WITHOUT DYNAMIC STEERING, Vehicles with 6-Cylinder Diesel Engine: Notes

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Hose Clamps - Up To 25 mm 3094
Counterhold - Multiple Use T10172A with Adapter T10172/5
Hose Clip Pliers VAG1275A
Torque Wrench 1331 5-50Nm VAG1331
Used Oil Collection and Extraction Unit SMN372500
Shop Crane - Drip Tray VAS6208
Torx Socket - T60 T40087
Wrench - Door Adjusting 3320 with Wrench - Door Adjusting - Box Wrench 3320/2
Engine Bung Set VAS6122

Power Steering Pump, Removing and Installing, 6-Cylinder Diesel Engine, Vehicles without Dynamic Steering, refer to REMOVING .

Overview - Power Steering Pump

NOTE:

Replace seals.

Do not reuse fluid you have drained.

Only use Hydraulic Fluid.

Fig 1: Overview Of Power Steering Pump, Vehicles Without Dynamic Steering With 6-Cylinder Engine

Courtesy of AUDI OF AMERICA, LLC

Bracket
Sleeve
- Drive the sleeve back slightly to install the power steering pump.
Bolt
- 23 Nm
- 20 Nm, this tightening specification applies only with the Wrench - Door Adjusting 3320
- To loosen and tighten, use the Wrench - Door Adjusting 3320 with the accompanying Wrench - Door Adjusting - Box Wrench 3320/2
Bolt
- 9 Nm
Seal
- Always replace if removed
Pressure Line
CAUTION:
- Insert the pressure line completely when installing.
- depending on the version, also mounted to the A/C compressor
Suction Hose
- The "P" marking on the suction hose -arrow- must align with the formed seam -arrow- on the power steering pump.
Clamp
- Tension using Hose Clip Pliers VAG1275A, refer to Figure
- Always replace if removed
Bolt
- 23 Nm
Belt pulley
- To remove and install, use the Counterhold - Multiple Use T10172A with the Counterhold - Kit - Adapter 2 T10172/2
Power Steering Pump
- Fill with Hydraulic Fluid before installing
- Delivery pressure, checking, refer to POWER STEERING PUMP, CHECKING DELIVERY PRESSURE .
- Removing and installing, refer to REMOVING .
- Bleed the steering, refer to STEERING, BLEEDING AFTER REPLACING .
- Check hydraulic fluid level, refer to POWER STEERING FLUID LEVEL, CHECKING .
- Steering System, checking for leaks, refer to STEERING, CHECKING FOR LEAKS .
Bolt
- 23 Nm