POWER STEERING PUMP, REMOVING AND INSTALLING, VEHICLES WITHOUT DYNAMIC STEERING, Vehicles with 4-Cylinder Diesel Engine: Notes

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Power Steering Pump, Removing and Installing, 4-Cylinder Diesel Engine, Vehicles without Dynamic Steering, refer to REMOVING .

Overview - Power Steering Pump, without Dynamic Steering

NOTE:

Replace seals.

Do not reuse fluid you have drained.

Only use Hydraulic Fluid.

Fig 1: Overview - Power Steering Pump, Vehicles With 4-Cylinder Diesel Engine (Vehicles Without Dynamic Steering)

Courtesy of AUDI OF AMERICA, LLC

Bracket
Sleeve
- Drive the sleeve back slightly to install the power steering pump.
Bolt
- 23 Nm
Bolt
- 9 Nm
Seal
- Always replace if removed
Pressure Line
CAUTION:
- Insert the pressure line completely when installing.
Suction Hose
- The "P" marking on the suction hose -arrow- must align with the formed seam -arrow- on the power steering pump.
Clamp
- Tension using Hose Clip Pliers VAG1275A, refer to Figure
- Always replace if removed
Bolt
- 23 Nm
- 20 Nm, this tightening specification applies only with the Wrench - Door Adjusting 3320
- To loosen and tighten, use the Wrench - Door Adjusting 3320 and the accompanying Wrench - Door Adjusting - Box Wrench 3320/2
Belt pulley
Power Steering Pump
- Allocation, refer to parts.
- Fill with Hydraulic Fluid before installing
- Delivery pressure, checking, refer to POWER STEERING PUMP, CHECKING DELIVERY PRESSURE, 4-CYLINDER DIESEL ENGINE, VEHICLES WITH AND WITHOUT DYNAMIC STEERING .
- Removing and installing, refer to REMOVING .
- Bleed the steering, refer to STEERING, BLEEDING AFTER REPLACING .
- Check hydraulic fluid level, refer to POWER STEERING FLUID LEVEL, CHECKING .
- Steering System, checking for leaks, refer to STEERING, CHECKING FOR LEAKS .
Bolt
- 23 Nm