Hydraulic Power Steering Gear, Adjusting
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm VAG1331
NOTE:
Two technicians are required for adjustments. Adjust with engine off.
-- Remove the noise insulation, refer to OVERVIEW - NOISE INSULATION .
-- Bring the power steering gear into the center position, refer to STEERING, CENTERING .
-- Turning the steering wheel back and forth (approximately 30° off center axis) will produce a rattling noise if steering play is too large.
-- The second mechanic must carefully screw the adjustment screw -arrow- until the knocking noise can no longer be heard inside the vehicle.
-- Perform a road test.
-- Make sure the steering returns to the center without sticking. Adjust the setting, if necessary.