Shift Lock Solenoid -N110-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressing Retaining Hooks Into Shift Mechanism

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

Tightening specification, refer to OVERVIEW - SELECTOR MECHANISM .

-- Turn the ball head -1- into the correct installed position.

-- Install the Shift Lock Solenoid -N110- at an angle from above into the selector mechanism and then tilt it under in the opposite direction of -arrow-.

The ball head -1- must engage completely in the operating lever on shift mechanism. Press it down using a small screwdriver if necessary.

-- Attach the Shift Lock Solenoid -N110- to the hook -A-.

-- Position the cover -A- over the Shift Lock Solenoid -N110- and carefully lock it in -1 through 3-.

Fig 2: Cap, Bracket And Tabs

Courtesy of AUDI OF AMERICA, LLC

-- Connect the electrical connectors.

-- Check the shift mechanism function before completing assembly, refer to GEARSHIFT MECHANISM, CHECKING .

-- Install the front ashtray, refer to FRONT ASHTRAY, REMOVING AND INSTALLING .