Overview - Selector Lever Cable
WARNING: This page is about a different car, the 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening specification: 13 Nm
- For selector lever cable adjustment
- Attached to the selector mechanism function unit
- O-Ring
- Replacing
- Clip
- For the selector lever cable on the selector mechanism function unit
- Bolt
- Tightening specification: 8 Nm
- Quantity: 2
- Selector Lever Cable Bracket
- Nut
- Tightening specification: 13 Nm
- Quantity: 2
- Securely mounted on the selector lever cable
- The selector lever cable is secured to the support bracket
- Selector Lever Cable
- Do not bend
- Removing and installing, refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING
- The selector lever cable must be replaced if the rubber grommet is damaged.
- Lubricate the ball socket lightly with Polycarbamide Grease G 052 142 A2 before installing.
- Make sure the rubber grommet on the transmission side is not twisted when installing.
- Checking and adjusting, refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .
- Gearshift Lever