Starter, Removing And Installing, Vehicles With 3.0L TDI Engine: Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening specifications, refer to OVERVIEW - STARTER .
Install in reverse order of removal. Note the following:
-- Make sure the seal -1- fits correctly inside the starter opening before installing the starter.
- The sealing piece must cover the opening for the starter -2- -arrow-.
-- Install the engine support and the right engine mount, refer to OVERVIEW - SUBFRAME MOUNT .
-- Install the lower right coolant pipe, refer to OVERVIEW - COOLANT PIPES .
-- Install the generator, refer to GENERATOR, REMOVING AND INSTALLING, VEHICLES WITH 3.0L TDI ENGINE .
-- Install the front exhaust pipe, refer to FRONT EXHAUST PIPE, REMOVING AND INSTALLING .
-- Connect the battery. Required actions, refer to BATTERY, DISCONNECTING AND CONNECTING .