Left auxiliary cooler, removing and installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Audi S4, 2008 Audi S4, 2007 Audi S4, 2006 Audi S4, and 2005 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Drip Tray For VAS 6100, VAS 6208

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drip tray for workshop crane VAS 6208

Removing

Drain coolant → Cooling system, draining and filling .
Bring lock carrier into service position → Lock carrier, moving into service position .

Fig 2: Disconnecting Coolant Hoses & Removing Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect coolant hoses - 1 - and - 2 -.
Remove bolt - arrow -.
Remove left auxiliary cooler.

Installing

Installation is in reverse order of removal, note the following:

NOTE:

Secure all hose connections using hose clamps appropriate for the model type .

Install lock carrier with attachments →
- 50 BODY, FRONT
- 50 - BODY - FRONT for BODY EXTERIOR - CABRIOLET
.

Fig 3: Placing Torque Support On Rubber Buffer For Torque Support

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Place torque support on rubber buffer for torque support and tighten bolts - arrows -.
Install front bumper cover →
- 63 BUMPER
- 63 - BUMPERS for BODY EXTERIOR - CABRIOLET
.
Fill with coolant Filling .

NOTE:

Complete coolant must be replaced if the radiator was replaced.

Check headlight adjustment →
- 01 - MAINTENANCE
- 01 - MAINTENANCE for MAINTENANCE PROCEDURES - CABRIOLET
.

Torque specifications

Component	Nm
Left auxiliary cooler to bracket	10