Dual-mass flywheel, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Audi S4, 2008 Audi S4, 2007 Audi S4, 2006 Audi S4, and 2005 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Transmission removed.

Remove clutch pressure plate → 30 CLUTCH .
Mark dual mass flywheel to crankcase.

Fig 1: Inserting Counter Hold Tool 10-201

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Insert counterhold tool 10-201 to loosen bolts.

Fig 2: Identifying Dual-Mass Flywheel & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

To prevent damage to dual-mass flywheel when removing, bolts - B - must not be removed using an air-powered or impact wrench. Only removing bolts by hand is permitted.

Rotate dual-mass flywheel - A - so that bolts stand centered to holes - arrows -.
When removing bolts, make sure that no bolt head makes contact on dual-mass flywheel because it will otherwise be damaged when further installing the bolt.