Headrest Guide, Removing And Installing, Super-Sport Seat: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Install in reverse order of removal. Note the following:

Headrest guide without release button

Fig 1: Headrest Guide Without Release Button

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When sliding the headrest guide -1- in, make sure the tab -3- engages correctly on the backrest frame -2-.

Ensure retaining tabs -arrows- are engaged in the backrest frame correctly.

Headrest guide with release button

Fig 2: Headrest Guide With Release Button

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When sliding the headrest guide -1- in, make sure the tab -3- engages correctly on the backrest frame -2-.

Ensure retaining tabs -arrows- are engaged in the backrest frame correctly.

Continuation for headrest guide without and with release button

NOTE:

Make sure the connectors are installed correctly and are secure.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to Connecting .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the DTC memory, erase it and check it again. Refer to Vehicle Diagnostic Tester.