Airbag Adapter, Connecting And Disconnecting

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Airbag Lockout Adapter VAS6281

Fig 1: Airbag Adapter VAS 6281
Courtesy of AUDI OF AMERICA, LLC

Disconnecting the airbag connector

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Disconnect the side airbag connector. Refer to CONNECTORS, DISCONNECTING AND CONNECTING .

Fig 2: Airbag Adapter VAS 6281

Courtesy of AUDI OF AMERICA, LLC

-- Connect Airbag Lockout AdapterVAS6281 to side airbag connector on seat side -1-.

CAUTION:

The Airbag Lockout AdapterVAS6281 must stay connected to seat until seat is installed again.

NOTE:

Ensure airbag adapter engages correctly.

Connecting the Airbag Connector

Connecting the airbag wiring harnesses happens in reverse order, noting the following:

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

NOTE:

Make sure the connectors are installed correctly and are secure.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to Connecting .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the DTC memory, erase it and check it again. Refer to Vehicle Diagnostic Tester.