Shift Lock Solenoid -N110-: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2010 Audi A5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order, paying attention to the following:
- Tightening specification, refer to SELECTOR MECHANISM OVERVIEW .
-- Turn the ball head -1- into the correct installed position.
-- Install the shift lock solenoid at an angle into the selector mechanism and then tilt it opposite the direction of the -arrow-.
- The ball head -1- must engage completely in the operating lever on shift mechanism. Press it down using a small screwdriver if necessary.
-- Attach the shift lock solenoid to the hook -A-.
-- Position the cover -A- over the shift lock solenoid and carefully lock it in -1 through 3-.
-- Connect the electrical connectors.
-- Check the shift mechanism function before completing assembly. Refer to SELECTOR MECHANISM, CHECKING .
-- Install the front ashtray. Refer to FRONT ASHTRAY, REMOVING AND INSTALLING .
-- Install the multimedia system control head. Refer to MULTIMEDIA SYSTEM CONTROL HEAD -E380-, REMOVING AND INSTALLING .