Overview - Secondary Air System, Market-Specific 1
WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 9 Nm
- Bonded Rubber Bushing
- Secondary Air Injection Pump Motor -V101-
- Removing and installing. Refer to SECONDARY AIR PUMP, REMOVING AND INSTALLING, MARKET-SPECIFIC 1 .
- Attach the connector to the bracket
- Check in "Guided Functions " using the Vehicle Diagnostic Tester.
- O-Rings
- Replace
- Secondary Air Hose
- Retaining Clip
- O-Ring
- Replace
- Seal
- Replace
- Bolts
- 9 Nm
- Right Secondary Air Injection Combination Valve
- Checking. Refer to SECONDARY AIR INJECTION COMBINATION VALVES, CHECKING FOR FUNCTION AND LEAKS, MARKET-SPECIFIC 1 .
- Removing and installing. Refer to SECONDARY AIR INJECTION RIGHT COMBINATION VALVE, REMOVING AND INSTALLING, MARKET-SPECIFIC 1 .
- Bolt
- 9 Nm
- Secondary Air Hose
- Bolt
- 9 Nm
- Left Secondary Air Injection Combination Valve
- Checking. Refer to SECONDARY AIR INJECTION COMBINATION VALVES, CHECKING FOR FUNCTION AND LEAKS, MARKET-SPECIFIC 1 .
- Removing and installing. Refer to SECONDARY AIR INJECTION LEFT COMBINATION VALVE, REMOVING AND INSTALLING, MARKET-SPECIFIC 1 .
- Bolts
- 9 Nm
- Seal
- Replace
- Bolt
- 9 Nm
- Bracket
- For the secondary air injection hose
- O-Ring
- Replace
- Secondary Air Hose
- Bracket
- For Secondary Air Injection Pump Motor -V101-
- Bolt
- 9 Nm
-- Tighten the heat shield screws -arrows- -1- to 9 Nm.