Selector Lever Cable, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to OVERVIEW - SELECTOR LEVER CABLE .

NOTE:

Replace the O-ring on the selector lever cable.

Lubricate the cable eye and the ball socket on the selector lever cable with Polycarbamide Grease G 052 142 A2 before installing.

-- Slide the noise insulation -2- over the opening on the selector lever cable -3-.

Fig 1: Identifying Sound Insulation And Lock Washers

Courtesy of AUDI OF AMERICA, LLC

-- Insert the O-ring -1- on the selector lever cable.

Fig 2: O-Ring, Selector Lever Cable And Clip

Courtesy of AUDI OF AMERICA, LLC

-- Install the selector lever cable -2- into the gearshift mechanism function unit -arrow-.

-- Secure the selector lever cable -2- with the circlip -3-.

Installed position: the angled end of the circlip -1- faces the selector mechanism.

Fig 3: Identifying Selector Lever Cable Retaining Clip Sideways & Selector Lever Cable From Shift Mechanism
Courtesy of AUDI OF AMERICA, LLC

-- Install the noise insulation -2- with four new lock washers -1-.

Fig 4: Identifying Sound Insulation And Lock Washers

Courtesy of AUDI OF AMERICA, LLC

-- Push the selector shaft lever -1- on the transmission all the way to the back in direction of -arrow- until the parking lock locks into place.

Fig 5: Identifying Selector Lever

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When parking lock is engaged, it must not be possible to turn the front wheels.

-- Push the selector lever into "D".

-- Make sure the selector lever inside the vehicle is also in "D".

-- Carefully press the selector lever cable ball socket -1- in this position onto the selector shaft lever.

Fig 6: Ball Socket And Securing Clips

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do not bend selector shaft lever when pressing on, otherwise shift mechanism can no longer be adjusted exactly.

-- Secure the selector lever cable using a clip -2-.

NOTE:

Do not bend or kink the selector lever cable.

-- Check and adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .