Overview - Selector Lever Cable
WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Clip
- For selector lever cable
- Replacing
- Bolt
- 8 Nm
- Quantity: 2
- Selector Lever Cable
- Do not bend
- Removing and installing. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING
- The selector lever cable must be replaced if the rubber grommet is damaged.
- Lubricate the ball socket lightly with Polycarbamide Grease G 052 142 A2 before installing.
- Make sure the rubber grommet on the transmission side is not twisted when installing.
- Checking and adjusting. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING
- Cable Mounting Bracket
- Bolt
- 13 Nm
- For selector lever cable adjustment
- Attached to the selector mechanism function unit
- O-Ring
- Replacing
- Selector Shaft Lever