Left Coolant Pipes, Removing And Installing: Installing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - COOLANT PIPES .

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-rings.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Clean and smooth the o-ring sealing surface.

-- Coat the o-ring with coolant and slide it onto the coolant pipe.

-- Install the A/C compressor bracket. Refer to OVERVIEW - RIBBED BELT DRIVE .

-- Install the A/C compressor. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING .

-- Install the After-Run Coolant Pump -V51-. Refer to After-Run Coolant Pump -V51-, REMOVING AND INSTALLING .

-- Fill the coolant. Refer to FILLING .