Overview - Seals
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
The shaft seals -C-, -D-, and -E- can be replace with the transmission installed. Refer to SEALS .
- Shaft Seal
- For the input shaft
- Refer to INPUT SHAFT SEAL, REPLACING
- Shaft Seal
- For the left flange shaft
- Refer to LEFT SEAL, REPLACING
- Shaft Seal
- For the right flange shaft
- Refer to RIGHT SEAL, REPLACING .
- Replacing with the transmission installed.
- Shaft Seal
- For the rear flange shaft or transmission output shaft with splines
- Removing and installing. Refer to CENTER DIFFERENTIAL HOUSING, SERVICING .
- Shaft Seal
- For the selector shaft
- Refer to Fig 2
- Replacing with the transmission installed. Refer to SELECTOR SHAFT SEAL, REPLACING
- Right Flange Shaft
- Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING
- Replacing with the transmission installed. Refer to RIGHT SEAL, REPLACING
- Final Drive Cover
- Refer to FINAL DRIVE COVER, REPLACING
- O-Ring
- On the final drive cover
- Replacing. Refer to FINAL DRIVE COVER, REPLACING .
- Differential
- Refer to OVERVIEW - DIFFERENTIAL
- Refer to DIFFERENTIAL, REMOVING AND INSTALLING
- Transmission
- Removing and installing. Refer to TRANSMISSION, REMOVING AND INSTALLING .
- Transmission Output Shaft with Splines
- With vibration damper; allocate correct components.
- Replace the shaft seal when replacing the transmission output shaft with splines -D-
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Transmission Output Shaft with Splines
- Without vibration damper; allocate correct components.
- Replace the shaft seal when replacing the transmission output shaft with splines -D-
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Dust Ring
- Replace after removing
- Rear Flange Shaft
- With and without vibration damper, allocate correct components.
- Removing and installing. Refer to CENTER DIFFERENTIAL HOUSING, SERVICING REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Left Flange Shaft
- Clutch Module
- Removing and installing. Refer to CLUTCH MODULE, REMOVING AND INSTALLING .
- Bolt