Gear Oil, Checking Level, Front Final Drive

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Used Oil Collection and Extraction Unit SMN372500
Protective eyewear

Procedure

Gear oil temperature at approximately 20 °C (68 °F) (room temperature).
Move the vehicle onto a 4-column shop hoist or over a work pit so it is completely level.
Tightening specification. Refer to OVERVIEW - FINAL DRIVE .

NOTE:

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

Clean working conditions for the automatic transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Always maintain the specified transmission fluid level. The transmission is very sensitive to overfilling.

Follow all applicable disposal regulations.

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Remove the plug -arrow-.

Fig 1: Gear Oil Level In Front Final Drive, Checking And Filling

Courtesy of AUDI OF AMERICA, LLC

Specified value: the oil level is correct when the front final drive is filled to the lower edge of the filler hole.

-- Allow the excess gear oil to drain if necessary.

-- Add gear oil if necessary until it runs out of the gear oil filler hole.

Transmission fluid.

NOTE:

Replace the drain plug and gasket.

-- Tighten the new sealing plug.