Final Drive 0BF, Removing And Installing, AUDI RS4 And RS5: Installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. At the same time note the following:

WARNING:

Malfunctions on the rear final drive.

If the rear final drive was replaced, additional work is necessary. Refer to ADDITIONAL WORK AFTER REPLACING REAR FINAL DRIVE 0BE, 0BF .

Tightening specifications. Refer to OVERVIEW - FINAL DRIVE 0BF, AUDI A4, A5, A6, AND A7 .

-- Attach the driveshaft to the rear final drive. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Install the driveshaft. Refer to INSTALLING .

-- Install the exhaust system and align free of tension. Refer to EXHAUST PIPES/MUFFLERS for engine code CALA, EXHAUST PIPES/MUFFLERS for engine codes CAED, CAEB, CPMB, CPMA, or EXHAUST PIPES/MUFFLERS for engines CCBA, CGXC, CTUB .

-- Install the rear cross member. Refer to OVERVIEW - TUNNEL BRACE .

-- Check the ATF inside the rear final drive. Refer to ATF LEVEL, CHECKING, 0BE, 0BF .

-- Check the gear oil level in the rear final drive. Refer to GEAR OIL, CHECKING LEVEL, 0BE, 0BF .

If the rear final drive was replaced, additional work is necessary. Refer to ADDITIONAL WORK AFTER REPLACING REAR FINAL DRIVE 0BE, 0BF .