LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 529 (Fuel Supply - Engine Code(S): CAEB, CAED, CALA, CCBA, CGXC, CPMA, CPMB & CTUB (Sedan)) >> 20 Fuel Supply >> Fuel Pump >> Fuel Pump Control Module -J538-, REMOVING AND INSTALLING >> Fuel Pump Control Module -J538-, REMOVING AND INSTALLING, VEHICLES WITH FWD AND AWD >> Removing

Fuel Pump Control Module -J538-, REMOVING AND INSTALLING, VEHICLES WITH FWD AND AWD: Removing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Follow all safety precautions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

WARNING:

Danger due to escaping fuel.

  • To prevent large quantities of fuel from coming out of the Fuel Pump Control Module - J538- when removing, fuel tank may only be a maximum of 1 /4 full.

-- Empty the fuel tank if necessary. Refer to FUEL TANK, DRAINING, VEHICLES WITH FWD AND AWD .

-- Move the passenger seat all the way forward if necessary.

CAUTION:

Risk of destroying electronic components when disconnecting the battery.

  • Observe the steps for disconnecting the battery.

-- Disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the rear bench seat. Refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .

Fig 1: Identifying Cover Bolts For Locking Flange
GWWA20-0803Courtesy of AUDI OF AMERICA, LLC

-- Remove the locking flange cover -arrows-.

A5 from MY 2011, A4 from MY 2012 

Fig 2: Disconnect Connectors
GWWA20-10345Courtesy of AUDI OF AMERICA, LLC

-- If equipped, disengage the connector -3- to the parking heater metering pump at the locking flange and move it to the side.

-- Open the connector locking mechanism with the Elbow Assembly Tool T10118 and disconnect the connector -2- on the locking flange.

-- Disconnect the connector -1- on the sealing flange.

-- Push the circlip -1- upward in direction of -arrow A- and squeeze the release in direction of -arrow B-.

Fig 3: Pulling Lock -1- Upward -Arrow A- & Press -Arrow B-
GWWA97-10641Courtesy of AUDI OF AMERICA, LLC
Fig 4: Connecting Fuel Lines -1 And 2-
GWWA20-10349Courtesy of AUDI OF AMERICA, LLC
WARNING:

There is a risk of injury because the fuel is under high pressure.

  • To reduce pressure in fuel system, lay a clean cloth around the connector and carefully loosen connector.

-- Remove the fuel line -2- from the locking flange. Refer to CONNECTOR COUPLINGS, SEPARATING .

-- Disconnect the fuel line -1- to the auxiliary heater metering pump at the locking flange, if necessary. Refer to CONNECTOR COUPLINGS, SEPARATING .

A5 from MY 2012, A4 from MY 2013 

Fig 5: View Of Fuel Delivery Unit Harness Connectors
GWWA20-11250Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- to the auxiliary heater metering pump at the locking flange, if necessary.

-- Open the connector locking mechanism with the Elbow Assembly Tool T10118 and disconnect the connectors -1 and 3- on the locking flange.

Fig 6: View Of Fuel Delivery Unit Fuel Line Connectors
GWWA20-11251Courtesy of AUDI OF AMERICA, LLC
WARNING:

There is a risk of injury because the fuel is under high pressure.

  • To reduce pressure in fuel system, lay a clean cloth around the connector and carefully loosen connector.

-- Remove the fuel line -2- from the locking flange. Refer to CONNECTOR COUPLINGS, SEPARATING .

-- Disconnect the fuel line -1- to the auxiliary heater metering pump at the locking flange, if necessary. Refer to CONNECTOR COUPLINGS, SEPARATING .

Continuation for All Vehicles 

Fig 7: Removing Union Nut Using Fuel Tank Sender Unit Tool T40068A
GWWA20-10406Courtesy of AUDI OF AMERICA, LLC
WARNING:

Danger due to escaping fuel.

  • To prevent large quantities of fuel from leaking out of the locking flange when removing, the fuel tank may only be a maximum of 1 /4 full.

-- Use a Fuel Tank Sender Unit Tool T40068A to remove the union nut in direction of -arrow-.

NOTE:

When union nut is loosened, plastic catch on threaded ring breaks off - ignore.

-- Cover the fuel tank opening with a clean cardboard box -1- to prevent dirt from falling into it.

Fig 8: Cover The Fuel Tank Opening
GWWA20-10407Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

-- Remove the Fuel Pump Control Module -J538- -1- toward the inside between the fuel tank and the underbody.

Fig 9: Fuel Pump Control Module
GWWA20-10408Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector and remove the fuel pump control module.