Guidelines For Clean Working Conditions
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Even Very Small Particles of Dirt Can Cause a Fault. When Working on the Fuel Supply and Fuel Injection System, Observe the following Guidelines for a Clean Working Environment:
- Before loosening, connections and surrounding areas must be cleaned thoroughly with engine or brake cleaner, and then cleaned area must be dried completely.
- Immediately seal off lines and connections with clean plugs or protective caps.
- Place the removed parts on a clean surface and cover them. Only use lint-free cloths!
- Carefully cover or seal opened components if the repair will not be done immediately.
- Install only clean parts: remove the replacement parts from their packaging just before installing them. Do not use parts that have been stored outside of their original packaging (for example in tool boxes etc.).
- If the system is open: do not work with compressed air. If possible do not move vehicle.
- Protect any disconnected connectors from dirt and moisture and connect them only when they are completely dry.