Overview - Drive Plate
WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For the assembly work, secure engine with Engine/Transmission Holder - V6 FSI Bracket VAS6095/1-5 to Engine and Transmission Holder VAS6095. Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Drive Plate
- With the bearing flange
- Check the running surfaces on the bearing flange and the clutch module holes for cracks and signs of wear.
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Bolt
- 60 Nm + 90° additional turn
- Replace
- Needle Bearing
- Only for vehicles with manual transmission or multitronic 0AW
- Installed position: the closed side faces the engine
- Removing and installing NEEDLE BEARING IN DRIVE PLATE, REPLACING
- Sensor Wheel
- For Engine Speed Sensor -G28-
- Crankshaft
- Alignment Pin
- Crankshaft Shaft Seal, Transmission Side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .