Crankshaft Seal, Replacing, Transmission Side

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Seal Installer - Crankshaft T10122A
Puller - Crankshaft/Power Steering Seal T20143/2

Procedure

Fig 1: Prying Out Sealing Ring Using Extractor Lever T20143/2

Courtesy of AUDI OF AMERICA, LLC

The transmission is removed.

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Pry out the shaft seal using Puller - Crankshaft/Power Steering Seal T20143/2.

-- Clean the running and sealing surface.

-- Place the Seal Installer - Assembly Device T10122/1 on the Seal Installer - Pull Sleeve T10122/2 and slide the shaft seal -A- onto the pull sleeve.

Fig 2: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

Courtesy of AUDI OF AMERICA, LLC

-- Remove the assembly aid.

-- Position the Seal Installer - Pull Sleeve T10122/2 with shaft seal -1- on the crankshaft.

Fig 3: Identifying Pull Sleeve T10122/2 With Sealing Ring On Crankshaft

Courtesy of AUDI OF AMERICA, LLC

-- Press shaft seal in evenly all around with Seal Installer - Thrust Piece T10122/3 until flush.

Fig 4: Pressing In Seal Evenly All Around Until It Reaches Stop Using T10122/3

Courtesy of AUDI OF AMERICA, LLC

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .